Clean the printhead drop detector – HP Designjet Z6200 Photo Printer User Manual
Page 77
3.
Rub the cloth against the electrical contacts with a light force along the entire depth of the flex
connector. Try to avoid picking up any ink deposit that may have accumulated on the bottom
surface of the slot.
4.
Take special care to clean all contacts thoroughly, including the ones at the lowest point of the
connector.
5.
Using the same cloth, clean the strip of electrical contacts on the printhead (unless the printhead is
new). Avoid touching the printhead nozzles.
CAUTION:
Do not touch the surface of the printhead that contains the nozzles, because the
nozzles are easily damaged.
6.
After waiting a few moments to allow both connectors to dry, replace the printhead into the
printhead carriage. See
7.
Wash or dispose of the cloth. Take care to prevent the transfer of ink onto hands and clothing.
If the front panel continues to show the Reseat or Replace message, replace the printhead or contact
your HP customer service representative.
Clean the printhead drop detector
The printhead drop detector is a sensor that detects which nozzles on the printheads are not printing,
so that other nozzles can substitute for them. If particles block the sensor (such as fibers, hair or small
pieces of paper), print quality is affected.
When the front panel displays a warning message that the drop detector needs cleaning, you are
recommended to clean it. If you do not clean it immediately, the printer continues working normally, but
the front panel display continues to show the warning.
CAUTION:
Wear gloves to avoid getting ink on your hands.
ENWW
Work with ink system components
69
Ha
nd
le
the
ink sys
tem