Installing xp external storage, Preparing for xp external storage settings, 22 preparing for xp external storage settings – HP StorageWorks XP Remote Web Console Software User Manual

Page 22: Installing external storage xp, Preparing for external storage xp settings

Advertising
background image

Requirement

Item

1,024 per port

Maximum number of external LUs
addressable per local array port

For the XP12000, 15,360 volumes can be connected

For the XP10000/SVS200, 8,192 volumes can be connected

1,024 volumes can be connected per port

NOTE:

If you use HP StorageWorks XP Snapshot Software, the number of
external LUs that can be connected is as follows:

For the XP12000:

Number of external LUs + Number of virtual LUs

15,360

For the XP10000/SVS200:

Number of external LUs + Number of virtual LUs

8,192

NOTE:

A LUN ID of a connected external volume should be set in the range
of 0 – 1,023. An external volume that has a LUN ID equal to or
larger than 1,024 cannot be connected.

Maximum number of external LUs
that can be connected

8

Maximum number of FC paths that
can exist to one external LU

2 TB (4,294,967,296 blocks) per external LU (OPEN-V)
If you specify an external LU that is larger than 2 TB, you can only access
data stored in the field up to 2 TB.

Maximum capacity of an external
LU

About 38 MB (77,760 blocks) per external LU (non-OPEN-V)
When the volume's emulation type is OPEN-V, minimum capacity is about
47 MB (96,000 blocks) per external LU.

Minimum capacity of an external
LU

Installing XP External Storage

To perform XP External Storage operations with XP Command View Advanced Edition Software or
Remote Web Console, you must install an XP External Storage license key.

1.

Start XP Command View Advanced Edition Software or Remote Web Console for the local array.

2.

Enable the XP External Storage options in XP Command View Advanced Edition Software or
Remote Web Console and on each XP External Storage array.

For instructions, see the HP StorageWorks XP Command View Advanced Edition Software user guide
for XP Disk Arrays
or the HP StorageWorks XP Remote Web Console user guide for XP12000/XP10000
Disk Arrays and SVS 200
.

Preparing for XP External Storage settings

Before using XP External Storage, collect the information necessary for defining its settings. The
following information is required:

Preparing for XP External Storage operations

22

Advertising
This manual is related to the following products: