Connecting xp12000/xp10000 disk arrays – HP StorageWorks XP Remote Web Console Software User Manual
Page 168
The volume may have been set as a pair volume for data copy. Check if the
volume is set as a pair volume of XP Business Copy Software, XP Continuous
Access Synchronous, XP Continuous Access Journal or some other copy program.
If the volume is set as a pair volume, the volume may be protected because of
the pair status. When the volume is protected, change the pair status or delete
the pair.
The access attribute of the volume may have been changed by Data Retention
Utility. Check the access attribute of the volume. If the volume is protected by the
access attribute, release the protection.
Illegal request
The volume may have been set as a pair volume for data copy. Check if the
volume is set as a pair volume of XP Business Copy Software, XP Continuous
Access Synchronous, XP Continuous Access Journal or some other copy program.
If the volume is set as a pair volume, the volume may be protected because of
the pair status. When the volume is protected, change the pair status or delete
the pair.
The access attribute of the volume may have been changed by Data Retention
Utility. Check the access attribute of the volume. If the volume is protected by the
access attribute, release the protection.
Response error
There is a problem with connection to the external array. The following are possible
causes:
•
The fibre cable is not physically connected in the proper way.
•
The setting of the topology does not match between the external port and the
target port.
•
If the external array is connected through switches, the settings for the switches
may not be appropriate.
Check if the fibre cable is connected properly, and then set the Fibre Channel
port properly using XP LUN Configuration and Security Manager Software.
The LUN security may have been enabled by the XP LUN Configuration and
Security Manager Software.
Check if the LUN security is enabled or not. If the LUN security is enabled, disable
the LUN security.
Cannot detect port
Connecting XP12000/XP10000 Disk Arrays
When connecting an XP12000/XP10000 Disk Array as the external array, you need to set the port
to the host group for the Windows hosts (host mode 0C: Windows, host mode 2C: Windows Extension).
Also, the port attribute must be the target or RCU target port.
Notes on connecting external arrays
168