Avenview RTERM Series User Manual
Page 22
www.avenview.com
22
Personality
Sets the terminal’s operating mode to Wyse 325, Wyse 120/Wyse 60 (native mode), Wyse
50+ (WY-50, WY-50+, WY-100, ADM 31/5/3a), TeleVideo TVI 925, TVI910+ (includes 910),
ADDS A2, Digital Equipment VT-100, VT-220 7 bits, VT-220 8 bits, VT-52, Console ANSI, PC
TERM, PCG Alpha.
Scroll Speed
Sets the display scroll rate to Jump (the rate data is received), Smooth-8 (eith lines per
second), Smooth-4, Smooth-2, or Smooth-1
Rcvd CR
Causes the cursor to move to the beginning of the current line (CR) or the beginning of the
next line (CRLF) when the terminal receives an ASCII CR.
Enhance
Allows the terminal to recognize an enchanced set of codes when the terminal is not in the
native personality.
Auto Scroll
Causes the data to scroll up a line when the cursor moves past the last line of the page.
Monitor
Causes the terminal to display symbols for escape sequences and control codes without
acting on them (Test Feature).
Status Line
Sets the top line of the screen as the status line.
End of Line
Warp
Causes the cursor to move to the start of the next line when additional characters are
entered at the end of a line.
Attribute
Sets display attributes to be assigned to each character as it is entered (Char), to be active
to the end of the line (Line), or to be active to the end of the page (Page).
Xmt Limit
Causes the terminal to send data through the HOST port as the baud rate allows (None) or
at a maximum rate of 60 cps or 150 cps. In older system limiting character rate is necessary
to prevent loss of data.
Language
Sets correct terminal operating for the language of keyboard connected to it: US, UK,
Danish, German, Spanish, Swedish, Norwegian, Italian, French, Belgian, French, German.
Key Repeat
Off, 1 … 8 8 different repeat rates after a key has been depressed for about 1/2.
Margain Bell
Sets the terminal’s bell to ring when the cursor reaches the column where the bell is set
(default is column 72 in 80-column mode or 124 in 132 column mode).
Keycode
Sets the terminal to send normal ASCII characters *ASCII) or PC-type scan codes for every
key up / down (Scan). Scan is required for the PC Term personality.
Keyclick
Sets the terminal to sound a muted beep each time a key is pressed or repeated.
NRC
Sets the terminal to have national replacement character functional.
Bell Volume
Off, 1, 2, 3 (3 different volume)
Num Start
Off / On when the terminal power on, this field determines whether the numeric pad starts
as Numeric (NUM On) or Function (NUM Off).