Avenview RTERM Series - Manual (Page 54)

www.avenview.com 54
Note:

The Power Control Mode is available in port #1 only.

The last port (e.g. Port#16 of IPCS-16) can also be used as External ESP (Entry Serial Port) in
Serial-to-Serial operation mode. Refer to the section Serial-to-Serial Function for details.
Console Server Mode:
Configuring a serial port as a console server creates a TCP socket on the IP serial console unit that listens for a
Telnet or SSH client connection. When you connect to the TCP socket, you have access to the device attached to
the serial port as if the device were connected directly to the network. Data streamcan be sent back and forth
between the device and the Telnet/SSH client program.RawTCP is also supported with the Console Server
Mode.
For console server mode, the user can configure the following parameters:
Listening TCP port number
The user can also access a serial port through the IP address of the IP serial console and the listening TCP port
number of the serial port. If the IP address of the IP serial console and the serial port are assigned as
192.168.123.100 and listening TCP port number 4001, the user can connect to the port as follows: telnet
192.168.123.100 4001