Avenview RTERM Series - Manual (Page 45)

www.avenview.com 45
Section 3: IP Setting
3.1 IP Configuration
User can do the network IP settings via V-100 or web pages. This chapter describes the usage of web pages.
The default IP settings are as follows.
3.1.1 IP Configuration
The IP serial console requires a valid IP address to operate within the user’s network environment. If the IP
address is not readily available, contact the system administrator to obtain a valid IP address for the IP serial
console. Please note that the IP serial console requires a unique IP address to connect to the user’s network.
There are two types of IP assignments user can choose from:

Static IP

DHCP (Dynamic Host Configuration Protocol)
The IP serial console is initially defaulted to Static IP mode, with a static IP address of 192.168.123.211.
*The configuration setting will not go into effect until clicking the button Save to flash & reboot.
3.1.2 SMTP Configuration
The IP serial console (IPCS) can send an email notification when the number of system log messages reaches to
certain value and/or when an alarm message is created due to an issue with serial port data.
The user must configure a valid SMTP server to send these automatically generated emails.
The “device mail address” must be registered to SMTP server.
The IPCS supports two SMTP server types:
 SMTP without authentication
 SMTP with authentication
The SMTP user name and SMTP user password are required when selecting SMTP with Authentication.