Changing pool information, New pool pane, Ol pane – HP StorageWorks XP Remote Web Console Software User Manual
Page 54: Figure, Figure 10
Figure 10 New Pool pane
•
Pool ID: Pool ID. Enter a number from 0 to 127.
NOTE:
Do not enter a pool ID that another pool is already using. If you enter a pool ID that another pool
is already using and click
Set, an error message appears. In that case, enter a different number
for the new pool ID.
•
Threshold: Threshold of the pool usage rate between 20 and 95.
NOTE:
The threshold unit is percent (%). If the pool usage rate exceeds the threshold, the pool status
changes to Warning. You cannot create new XP Snapshot pairs to a pool in Warning status. Be
careful not to set too small a value for the threshold.
•
Attribute: Software product that uses the pool.
•
Set button: Creates a new pool according to settings in the New Pool pane, and closes the pane.
•
Cancel button: Cancels settings in the New Pool pane, and closes the pane. No pool is created.
Changing pool information
After creating a pool, the only setting you can change is the threshold.
1.
Change Command View XP or Remote XP Remote Web Console to Modify mode. For instructions,
see the HP StorageWorks Command View XP user guide for XP Disk Arrays or the HP
StorageWorks XP Remote Web Console user guide for XP12000/XP10000/SVS200.
2.
Select and right-click the pool you want to change, and select Change Pool Information. The
Change Pool Information pane (
on page 55) appears.
NOTE:
If the pool usage rate is 95% or higher, the shortcut menu does not appear.
3.
Select the threshold value from the Threshold list.
NOTE:
In the
Threshold list, only values higher than the pool usage rate appear.
XP Snapshot operations
54