HP StorageWorks XP Remote Web Console Software - Manual (Page 55)

4. Click Set. The Change Pool Information pane closes.
5. Click Apply. A confirmation message appears.
6. Click OK. The confirmation message closes, and the setting change is applied to the array.
Figure 11 Change Pool Information pane
Items in the Change Pool Information pane are the same as those in the New Pool pane. However,
in the Change Pool Information pane, you cannot enter or select items other than the Threshold list.
For more information about items in the Change Pool Information pane, see
“
Creating new pools ” on page 52.
Deleting pools
Usually, you specify one pool and delete only the specified pool. However, you can delete multiple
pools at one time if necessary. This section describes procedures for deleting one specified pool and
deleting multiple pools at one time.
Deleting one pool
1. Change Command View XP or XP Remote Web Console to Modify mode. For instructions, see
the HP StorageWorks Command View XP user guide for XP Disk Arrays or the HP StorageWorks
XP Remote Web Console user guide for XP12000/XP10000/SVS200.
2. Select and right-click the pool you want to delete, and select Delete Pool. A confirmation message
appears.
3. Click OK. The selected pool's icon changes to the icon indicating the deleting process.
4. Click Apply. A confirmation message appears.
5. Click OK. The confirmation message closes, and the pool is deleted from the array.
Deleting multiple pools
CAUTION:
If you execute this operation, all pools that can be deleted are deleted. If there are any pools you do
not want to delete, you must delete one pool at a time by following the steps in
“
Deleting one pool ” on page 55.
1. Change Command View XP or XP Remote Web Console to Modify mode. For instructions, see
the HP StorageWorks Command View XP user guide for XP Disk Arrays or the HP StorageWorks
XP Remote Web Console user guide for XP12000/XP10000/SVS200.
XP Snapshot User Guide 55