Antunes, AJ MS-150/155 - Manual (Page 10)

MIRACLE STEAMER
10 P/N 1010699 Rev. M 12/06
OPERATION
General (All Units Except MS-150/250 -
Mfg. #9100424, 432, 433 & 439)
When the Operate button (Figure 5a) is pressed, power
is supplied to the water pump (MS-150/155/355) or
the solenoid valve (MS-250/255). The pump/solenoid
operates and water sprays onto the heated Steam
Generator. The water flashes immediately into live
steam and shoots down onto the product.
One of two operational modes can be used:
Single Shot or Timed Cycle
SINGLE SHOT
The Operate button is pressed to initiate a single steam
shot. The control board applies power to the water
pump/solenoid and a “shot” of steam occurs.
TIMED CYCLE
The control is used to set the desired cook time (up
to 99 minutes, 59 seconds). When the Start/Stop but-
ton is pressed, the Control Board applies power to the
water pump/solenoid at regular intervals for the dura-
tion of the displayed cycle time. The display counts
down to zero and, when the cycle is complete, sounds
an audible signal, and then reverts back to the original
programmed cycle time. The unit is ready for the next
cycle when the green ready light is on.
UP DOWN PRGM START/STOP
POWER
READY
Figure 5a. Operating Controls (all units EXCEPT
MS-150/250 Mfg. #9100424, 9100432, 9100433, &
9100439)
Ready Light
Rocker Switch
(Power On/Off)
Operate
Button
Message
Display
Start/Stop
Button
General (MS-150/250 - Mfg. #9100424,
9100432, 433, & 9100439 Only)
When the Single Shot button (Figure 5b) is pressed,
power is supplied to the Solenoid/Water Pump. The
solenoid/ water pump operates and water sprays onto
the heated Steam Generator. The water flashes imme-
diately into live steam and shoots down onto the prod-
uct.
One of two operational modes can be used:
Single Shot or Timed Cycle
SINGLE SHOT
The Single Shot button is pressed to initiate a single
steam shot. The Control Board applies power to the
Solenoid/Water pump and a “shot” of steam occurs.
TIMED CYCLE
The control is used to set the desired cook time (up
to 99 minutes, 59 seconds). When the Operate but-
ton is pressed, the Control Board applies power to
the solenoid at regular intervals for the duration of
the displayed cycle time. The display counts down
to zero and, when the cycle is complete, sounds an
audible signal, and then reverts back to the original
programmed cycle time. The unit is ready for the next
cycle when the green ready light is on.
UP DOWN SINGLE SHOT PROGRAM
POWER
READY
Ready Light
Rocker Switch
(Power On/Off)
Operate
Button
Message
Display
Single Shot
Button
Figure 5b. Operating Controls
(MS-150/250Mfg. #9100424, 9100432, 9100433,
&9100439 ONLY)