HP e-Commerce Server Accelerator sa7120 - Manual (Page 106)

C H A P T E R 6 HP e-Commerce Server Accelerator SA7100/SA7120 User Guide
96
Remote Telnet Sessions
NOTE: The default
password for Telnet
sessions is admin. This section contains procedures for accessing the SA7100/SA7120’s
CLI via remote Telnet session.
Local Serial
Console Assign an IP address to the SA7100/SA7120’s network interface
using the following procedure:
HP SA7120> set ip
Enter IP [10.1.2.56]: 10.1.1.1
Enter Netmask [255.255.255.0]:
Verify the IP and netmask (optional):
HP SA7120> show ip
System IP Address : 10.1.1.1
System Netmask : 255.255.255.0
HP SA7120>
Enable remote Telnet sessions:
HP SA7120> set telnet enable
Configure the network route:
HP SA7120> set route
Enter Default Route (’none’ to delete)
[10.1.1.1] : <Enter>
Verify the route configuration (optional):
HP SA7120> show route
Default Route : 10.1.1.1
Delete a route configuration (optional):
HP SA7120> set route none
NOTE: To ensure that
this remote management
configuration persists
across a device shutdown
and startup, run the
config save command. Remote Telnet management is now enabled and configured on the
SA7100/SA7120. Now you can access the CLI from a remote Telnet
session.