HP e-Commerce Server Accelerator sa7120 - Manual (Page 85)

C H A P T E R 5 Command Reference
75
set ssh Enable or disable Secure Shell (SSH) sessions. When this
command is set to “enable” and an IP address is assigned to the
SA7100/SA7120’s network interface, you can access the device’s
CLI via remote SSH session. When disabled, the device refuses
SSH connections. Default: disable.
Syntax:
HP SA7120> set ssh <enable|disable>
show ssh Display current SSH status: enabled or disabled.
Example:
HP SA7120> show ssh
SSH: disabled
set ssh_port Set the port on which SSH connections are accepted. (Default port:
22.)
Syntax:
HP SA7120> set ssh_port <port>
where <port> is the number of the port to which SSH sessions
will connect.
show ssh_port Display port on which SSH sessions are currently accepted.
Example:
HP SA7120> show ssh_port
SSH Port Number: 22
setsnmp Enable or disable the SNMP agent. When enabled, you can set
configure SNMP information and parameters (see setsnmp
snmp_info, below) for the SA7100/SA7120. Default: disable.
Syntax:
HP SA7120> setsnmp <enable|disable>
showsnmp snmp Displays the current status of the SNMP agent: enabled or
disabled.
Example:
HP SA7120> showsnmp snmp
SNMP: Enable d
Command Description