HP e-Commerce Server Accelerator sa7120 - Manual (Page 77)

C H A P T E R 5 Command Reference
67
Port Mapping
Commands These commands are used to execute the operations described in
Chapter 3’s Mapping and Blocking sections.
set server_tmo Limits the period of time to establish a connection with the server.
If the connection is not established within the specified time, the
client request is rejected.
NOTE: Typical causes for server timeout include: server
powered off, server not accessible, application is not available on
the specified port.
Syntax:
HP SA7120> set server_tmo <n>
where <n> is a value in seconds between 5 and 36000.
show server_tmo Displays the currently specified server timeout value.
Example:
HP SA7120> show server_tmo
Server timeout [secs]: 5
HP SA7120>
Command Description
Command Definition
create block Create a block to preclude access to specified IP addresses or
through specified ports. A single IP, a single port, or all ports can
be blocked. If fewer than all ports are to be blocked, you must
repeat the create block command for each one.
Example:
HP SA7120> create block
Client IP to block [0.0.0.0]: 10.1.2.1
Client IP mask [0.0.0.0]: 255.255.0.0
Server IP to block [0.0.0.0]: 20.1.2.1
Server IP mask [0.0.0.0]: 255.255.0.0
Server Port to block: 80
Server Port mask [0xffff]:<Enter>
HP SA7120>