HP e-Commerce Server Accelerator sa7120 - Manual (Page 125)

C H A P T E R 7 Alarm Types
115
UTL:
Utilization
Threshold
Alarm This alarm monitors three utilization threshold values:
• CPU
• Connections per Second
• Total Open Connections
When enabled, an alarm is issued whenever any of the utilization
values exceeds its high-water mark, or, having exceeded the high-
water mark, drops below the low-water mark. The user defines the
high and low-water marks. By default, the high-water mark is 90%
and the low-water mark is 60%.
The data collected for utilization threshold metrics tends to be bursty,
so a smoothing algorithm is used to prevent continuous alarms.The
utilization window is a user-specified sliding interval during which
data is collected and averaged. Consequently, shorter intervals are
likely to result in some extraneous alarms. The interval can be set
from 5 to 65000 seconds (default: 15).
Format:
A:mm/dd/yyyy hh:mm:ss
UTL:ALRT|NMRL:CPU|CON|CPS:/*message*/
Where:
A: identifies the message as an alarm.
mm/dd/yyyy hh:mm:ss is the timestamp.
UTL: identifies the message as an Utilization
Threshold Alarm.
Alarm Modifiers and Messages
ALRT: Message: [CPU|Open connections|CPS] exceed
high water mark
NMRL: Message: [CPU|Open connections|CPS] drop
below low water mark
Extended Data
CPU: Indicates that CPU Utilization triggered
the alarm.
CON: Indicates that Total Active Connections
triggered the alarm.
CPS: Indicates that Connections per Second
triggered the alarm.