HP e-Commerce Server Accelerator sa7120 - Manual (Page 46)

C H A P T E R 4 HP e-Commerce Server Accelerator SA7100/SA7120 User Guide
36
Scenario 1—Single Server
This scenario describes a typical configuration of a SA7100/SA7120
with one server, using either automapping or manual configuration/
mapping. This scenario describes the fastest way to get up and
running with a SA7100/SA7120.
Single SA7100/SA7120, Single Server Installation
Procedure for
Scenario 1 Automapping
1. Physically connect the SA7100/SA7120 to the router and to one
server.
2. Initiate HTTPS traffic to the server. The SA7100/SA7120
monitors traffic and uses the initial mapping (with associated
default key and certificate) to decrypt HTTPS traffic and pass
clear text HTTP traffic to the server.
Manual Configuration
1. Perform the installation as described in Chapter 2. Access the
SA7100/SA7120 command prompt.
2. Acquire the appropriate keys and certificates following the
procedure in the “Keys and Certificates” section in Chapter 3.
3. Create a mapping for the server. Use the create map command
to specify the server IP address, ports, and keyID.
HP SA7120> create map
Server IP (0.0.0.0): 10.1.1.30
SSL (network) port [443]: <Enter>
Cleartext (server) port [80]: <Enter>
KeyID to use for mapping: myserver
Single Server
Router
HP e-Commerce Server Accelerator