EOTech CNVD-T (SU-232/PAS) Clip-On Night Vision Device - Thermal - Manual (Page 36)

2-20
2.13 SHUTDOWN PROCEDURES
a. Press and hold the POWER button for
approximately 3 seconds as the messages OFF?
then OFF! appear sequentially in the eyepiece
display. Release the POWER button when the
eyepiece display turns dark.
b. Install the objective lens cover over the objective
lens.
c. Remove all batteries; place batteries and the
CNVD-T in the soft carrying case.
2.14 EXTERNAL MONITOR
The CNVD-T is supplied with a video cable that is used to
connect the unit to an external monitor for viewing live
thermal imagery. The video cable is shown in Figure 2-17.
Figure 2-17 Video Cable
CNVD-T
Connector
BNC
Connector