EOTech CNVD-T (SU-232/PAS) Clip-On Night Vision Device - Thermal - Manual (Page 48)

3-6
3.3.3 Replacing Battery Door Lanyard . Vibra-Tite® (or
equivalent) and a T-7 Torx wrench are required to perform
this procedure.
NOTE
This procedure is best performed with the battery
door installed (closed).
NOTE
Because the lanyard mounting screw is installed at
the factory with a small amount of bonding
material, it is normal to encounter resistance when
removing it.
a. Use a T-7 Torx wrench to remove the lanyard
mounting screw.
b. If necessary, pull the lanyard over, and off, the
battery door thumbscrew.
c. Stretch the large eye of the replacement lanyard
over the battery door thumbscrew.
d. Feed the smaller eye of the lanyard down through
the slot in the battery door.
e. Arrange the battery door hardware so that the
pieces (e.g., washer, retaining lug, mounting screw)
can be assembled as shown in Figure 3-3.