PowerTap Joule 3.0 - Manual (Page 54)

Joule 3.0 User Guide page 54
Chapter 6: Sensors
Setting Up Resistance Unit Sensors
Joule 3.0 is compatible with CycleOps electronic resistance units (RU) found on the CycleOps
400 Pro indoor cycle and PowerBeam Pro trainer. In order to be paired, CycleOps electronic
resistance units need to be set for pairing by unplugging them for 5 seconds and the plugging
them back in.
1. Press and release [MODE] until Menu mode is displayed.
2. Press [JOYSTICK] in and release to select Sensors.
3. Press [JOYSTICK] up/down to highlight RU Sensor. Press [JOYSTICK] in and release to select RU Sensor.
4. Press [JOYSTICK] up/down to highlight Add New Sensor. Press [JOYSTICK] n and release to select Add New
Sensor.
5. Make sure the RU sensor has been unplugged and plugged back in in the last 30 seconds.
6. Press the [JOYSTICK] in and release to Start Pairing. Pairing may take up to 60 seconds. Once pairing is suc-
cessful, the sensor ID will be displayed.
7. Press [JOYSTICK] up/down to highlight Name. Press [JOYSTICK] in and release to select name and change
the name of the paired RU sensor. Press [JOYSTICK] in and release to save changes.
8. Press [JOYSTICK] up/down to highlight Activate Sensor. Press [JOYSTICK] in and release to Activate Sensor.
Note: active sensor is designated by a hash mark next to the sensor name in the sensor list. When switching RU
sensors, be sure to activate the appropriate sensor.
9. Once a sensor has been paired and activated Joule 3.0 will automatically find the active sensor whenever it is
turned on. Other resistance unit sensors with different IDs will be ignored. Once the sensor is paired, it can be
operated within the same area as other sensors without risk of picking up that signal.