Alcatel Carrier Internetworking Solutions 6648 - Manual (Page 183)

Troubleshooting IP Routing Troubleshooting via the CLI
OmniSwitch Troubleshooting Guide September 2005 page 12-7
Multicast packets sent = 0,
Broadcast packets received = 51008,
Broadcast packets sent = 155,
Input errors = 0
Output errors = 1
Collisions = 0
Dropped = 0
The show ip traffic command gives switch-wide statistics for traffic, and the “No Route Discards” statis-
tic should somewhat resemble the “icmp stats destination unreachable” number, in that both numbers
should be increasing at a similar rate. This can be misleading, as a number of “No Route Discards” on a
network is normal; the key here is to see that the numbers are increasing in similar proportion.
-> show ip traffic
Datagrams received
------------------------+------------
Total 426277
IP header error 0
Destination IP error 2
Unknown protocol 0
Local discards 0
Delivered to users 249109
Reassemble needed 0
Reassembled 0
Reassemble failed 0
Datagrams sent
------------------------+------------
Fowarded 1
Generated 178466
Local discards 426
No route discards 15
Fragmented 1
Fragment failed 0
Fragments generated 0
The show tcp ports command displays the TCP connection table.
-> show tcp ports
Local Address Local Port Remote Address Remote Port State
------------------+------------+-----------------+--------------+-------------
0.0.0.0 21
0.0.0.0 0 LISTEN
0.0.0.0 23 0.0.0.0 0 LISTEN
0.0.0.0 80 0.0.0.0 0 LISTEN
0.0.0.0 260 0.0.0.0 0 LISTEN
0.0.0.0 6778 0.0.0.0 0 LISTEN
0.0.0.0 7170 0.0.0.0 0 LISTEN
10.255.11.228 23 128.251.17.224 1677 ESTABLISHED
10.255.11.228 443 0.0.0.0 0 LISTEN
Output fields are described below: