Show tech-support layer3 – Alcatel Carrier Internetworking Solutions 6648 User Manual
Page 598
page -4
OmniSwitch Troubleshooting Guide
September 2005
show tech-support layer3
Creates a log file of the output of several Layer 3 Command Line Interface (CLI) commands.
show tech-support layer3
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6624, 6648, 7700, 7800, 8800
Usage Guidelines
•
This command creates a file called tech_support_layer3.log in the /flash directory of the output
produced by the show vlan router mac status, show ip router database, show ip traffic, show icmp
statistics, show tcp statistics, show tcp ports, show udp statistics, show udp ports, show vrrp,
show vrrp statistics, show ip slb, show ip route, and show arp CLI commands.
•
If an existing file called tech_support_layer3.log already exists then it will be overwritten when this
command is executed.
•
See the OmniSwitch CLI Reference Guide for more information on show commands.
•
Server Load Balancing (SLB) is not supported on OmniSwitch 6624 and 6648 switches and therefore
the show ip slb command output is not relevant for these switches.
Examples
-> show tech-support layer3
.............
Release History
Release 5.1; command was introduced.
Related Commands
Creates a log file of the output of system-wide CLI commands.
Creates a log file of the output of several Layer 2 CLI commands.