Alcatel Carrier Internetworking Solutions 6648 - Manual (Page 560)

page -174 OmniSwitch Troubleshooting Guide September 2005
debug qos
Configures the type of QoS events that will be displayed in the QoS log.
debug qos [info] [config] [rule] [main] [route] [hre] [port] [msg] [sl] [ioctl] [mem] [cam] [mapper]
[flows] [queue] [slot] [l2] [l3] [classifier] [nat] [sem] [pm] [ingress] [egress] [rsvp] [balance] [nimsg]
debug no qos
debug no qos [info] [config] [rule] [main] [route] [hre] [port] [msg] [sl] [ioctl] [mem] [cam] [mapper]
[flows] [queue] [slot] [l2] [l3] [classifier] [nat] [sem] [pm] [ingress] [egress] [rsvp] [balance] [nimsg]
Syntax Definitions
flows Logs events for flows on the switch.
queue Logs events for queues created and destroyed on the switch.
rule Logs events for rules configured on the switch.
l2 Logs Layer 2 QoS events on the switch.
l3 Logs Layer 3 QoS events on the switch.
nat Logs events for Network Address Translation policies. Not supported
for the OmniSwitch 6624/6648.
port Logs events related to QoS ports.
msg Logs QoS messages.
classifier Logs information whenever the switch classifies a flow; more details are
provided if the log level is higher.
info Logs basic information about the switch
config Logs information about the global configuration.
main Logs information about basic program interfaces.
route Logs information about routing.
hre Logs information about hardware route programming.
sl Logs information about source learning.
mem Logs information about memory.
cam Logs information about CAM operations.
mapper Logs information about mapping queues.
slot Logs events related to slots.
sem Logs information about semaphore, process locking.
pm Logs events related to the Policy Manager.
ingress Logs information about packets arriving on the switch.