Qos statistics, Debug qos, Qos statistics -11 debug qos -11 – Alcatel Carrier Internetworking Solutions 6648 User Manual
Page 161
Troubleshooting QoS
Troubleshooting QoS
OmniSwitch Troubleshooting Guide
September 2005
page 10-11
QoS Statistics
The show qos statistics CLI command displays statistics about the global QoS configuration as shown
below:
-> show qos statistics
QoS stats
Events
Matches
Drops
L2:
21
2
1
L3 Ingress:
0
0
0
L3 Egress:
0
0
0
IGMP Join:
0
0
0
Fragments: 0
Bad Fragments: 0
Unknown Fragments: 0
Sent NI messages: 9
Received NI messages: 4322
Failed NI messages: 0
Load balanced flows: 0
Reflexive flows: 0
Reflexive correction: 0
Flow lookups: 0
Flow hits: 0
Max PTree nodes: 0
Max PTree depth: 0
Flow hits: 0
Note. See the Omniswitch CLI Reference Guide for more information.
Debug QoS
The CLI command debug qos option configures the type of QoS events that will be displayed in the QoS
log. This command has the following syntax:
debug qos [info] [config] [rule] [main] [route] [hre] [port] [msg] [sl] [mem] [cam] [mapper] [flows]
[queue] [slot] [l2] [l3] [classifier] [nat] [sem] [pm] [ingress] [egress] [rsvp] [balance] [nimsg]
Note. See
for more information.
output definitions
Events
The number of Layer 2 or Layer 3 flows transmitted on the switch.
Matches
The number of Layer 2 or Layer 3 flows that match policies.
Drops
The number of Layer 2 or Layer 3 flows that were dropped.