Alcatel Carrier Internetworking Solutions 6648 - Manual (Page 189)

Troubleshooting IP Routing RIP Troubleshooting
OmniSwitch Troubleshooting Guide September 2005 page 12-13
RIP Troubleshooting
The following commands are used to troubleshoot RIP failures:
show ip rip interface //check for status enable and version Rip V1 or V2
show ip rip redis-filter
show ip rip
show ip rip peer
show ip rip routes
show ip rip debug //level 0 is disabled
7700-> ip rip debug-type ?
^
WARNING TIME SETUP SEND REDIST RECV RDB INFO ERROR
CONFIG ALL AGE
(IP Routing & Multicast Command Set)
To debug RIP:
1) ip rip debug-level 0
2) ip rip debug-type all
3) ip rip debug-level 255
4) ip rip debug-level 0
Verify the required parameters for a RIP interface using the show ip rip interface command:
-> show ip rip interface 11.40.150.1
Interface IP Address = 11.40.150.1,
IP Interface Number (VLANId) = 6,
Interface Admin status = disabled,
IP Interface Status = enabled,
Interface Config AuthType = None,
Interface Config AuthKey = ,
Interface Config Send-Version = v1,
Interface Config Receive-Version = v1,
Interface Config Default Metric = 1,
RIP Config Status = Active,
Received Packets = 0,
Received Bad Packets = 0,
Received Bad Routes = 0,
Sent Updates = 0
This interface can be configured for RIP v 1 or RIP v 2. Now, enable the RIP interface using the
command:
-> ip rip interface 10.40.150.1 status enable
->show ip rip interface
Intf Admin IP Intf Updates
IP Address vlan status status sent/recv(bad)
----------------+-----+----------+----------+---------------
11.40.211.4 2 enabled enabled 0/0(0)
11.41.211.4 3 enabled enabled 0/0(0)
9.9.1.1 4 enabled enabled 0/0(0)