Alcatel Carrier Internetworking Solutions 6648 - Manual (Page 289)

Troubleshooting PIM-SM Troubleshooting Examples: Limitations
OmniSwitch Troubleshooting Guide September 2005 page 16-27
Troubleshooting Examples: Limitations
Incorrect BSR ID
Turn on BSR debugging to view bootstrap messages:
-> ip pimsm debug-type bootstrap
-> ip pimsm debug-level 100
tPimsm-: Received bootstrap message from 192.168.11.1, bsr addr:192.168.13.1
on vlan 2
tPimsm-: RPF check failed for bootstrap msg. SA: 192.168.11.1,BSR
:192.168.13.1, vlan 2
tPimsm-: pimsmBSRStateTransition - Entering with Event TMR State : ELCTD
OperStatus UP
tPimsm-: BsrTimer Expired. Orig Message No State change
tPimsm-: pimsmBSRStateTransition - Leaving with Event TMR State : ELCTD
Status UP
tPimsm-: Sent BS on vlan 2 ipda = 224.0.0.13
An IP unicast routing issue causes this; the receiving router does not have a route entry for 192.16811.1.
Multicast Group Status is Shown as Disabled
-> show ip pimsm rp-candidate
Group Address RP Address Status
------------------+---------------+--------
227.1.1.1/32 192.168.12.2 disabled
226.1.1.1/32 192.168.12.2 disabled
This is caused by a missing C-RP address
-> show ip pimsm
Status = enabled,
BSR Address = 192.168.13.1,
BSR Expiry Time = 00h:01m:21s,
CBSR Address = 0.0.0.0,
CBSR Mask Length = 30,
CBSR Priority = 0,
CRP Address = 0.0.0.0,
CRP Hold Time = 150,
CRP Expiry Time = 00h:05m:00s,
CRP Interval = 60,
CRP Priority = 0,
Data Timeout = 210,
Join/Prune Interval = 60,
Max RPs = 32,
Probe Time = 5,
Register Checksum = header,
Register Suppress Timeout = 60
-> ip pimsm crp-address 192.168.12.2