Alcatel Carrier Internetworking Solutions 6648 - Manual (Page 41)

Troubleshooting the Switch System Dshell Troubleshooting
OmniSwitch Troubleshooting Guide September 2005 page 1-21
tCS_CVM Chassis Version Manager
SesMon_12 Session Monitor
tTelnetOut0e4208c Telnet Outgoing
tTelnetIn0 Telnet Incoming
CliShell0 CLI session 0 shell Task
tPolMonSvr Policy Manager Monitor LDAP Servers
tDcacheUpd FPGA Support
To further qualify the source of the problem we need to look at each and every NI.
Troubleshooting NIs on OmniSwitch 7700/7800/8800
Looking at the health statistics of each NI would give an idea about which one is causing the problem.
Following CLI command can be used to diagnose:
Show health <slot number>
Example:
-> show health 5
* - current value exceeds threshold
Slot 05 1 Min 1 Hr 1 Hr
Resources Limit Curr Avg Avg Max
----------------+-------+-----+------+-----+-----+-------
Receive
80 01 01 01 01
Transmit/Receive 80 01 01 01 01
Memory 80 39 39 39 39
Cpu 80 21 22 21 24
The NI Debugger software can be launched in Dshell using the following command:
Working: [dshell]-> <nidebug
This will launch the NI Debugger. To change to a specific slot and slice (Coronado) the following
command can be used:
changeSlot slot,slice
Now the processor on that slot can be accessed just like CMM to see all tasks (running or suspended),
tasks consuming the CPU the most, and other commands like task trace (tt) or task info (ti).
Working: [Kernel]->NiDebug
1:0 nidbg>
1:0 nidbg> nisup_cpuShow
1:0
1:0 Task Cpu
1:0 Id Name Abs Rel
1:0 -------- ----------- ---- ----
1:0 017fd170 tsHw_qdisp 13% 13%
1:0 015ea1c0 taIpni 2% 9%
1:0 015fae50 taVmnCtrl 0% 2%