Show tech-support layer3 dvmrp – Alcatel Carrier Internetworking Solutions 6648 User Manual
Page 604
page -10
OmniSwitch Troubleshooting Guide
September 2005
show tech-support layer3 dvmrp
Creates a log file of the output of several Distance Vector Multicast Routing Protocol (DVMRP)
Command Line Interface (CLI) commands.
show tech-support layer3 dvmrp
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 7700, 7800, 8800
Usage Guidelines
•
This command creates a file called tech_support_dvmrp.log in the /flash directory of the output
produced by the show ip dvmrp, show ip dvmrp prune, show ip dvmrp route, show ip dvmrp
neighbor, show ip dvmrp interface, show ip dvmrp nexthop, show ip dvmrp tunnel, and show ip
dvmrp debug CLI commands.
•
If an existing file called tech_support_dvmrp.log already exists then it will be overwritten when this
command is executed.
•
See the OmniSwitch CLI Reference Guide for more information on show commands.
•
See
for more information on debug commands.
Examples
-> show tech-support layer3 dvmrp
........
Release History
Release 5.1; command was introduced.
Related Commands
Creates a log file of the output of system-wide CLI commands.
Creates a log file of the output of several Layer 2 CLI commands.
Creates a log file of the output of several Layer 3 CLI commands.