Alcatel Carrier Internetworking Solutions 6648 - Manual (Page 63)

Troubleshooting Switched Ethernet Connectivity Verify Current Running Configuration
OmniSwitch Troubleshooting Guide September 2005 page 2-5
Verify Current Running Configuration
If the physical layer looks OK, then verify the configuration. Use the show configuration snapshot all to
display the current running configuration. Use this command to verify the ports that are involved are in the
correct VLAN. Also review the output of the command to verify there is nothing explicit in the configura-
tion that would cause the problem, such as a deny ACL that could be found under the QoS subsection.
-> show configuration snapshot all
! Chassis :
system name OS7800
! Configuration:
! VLAN :
vlan 7 enable name "VLAN 7"
vlan 7 port default 5/1
vlan 7 port default 5/2
! 802.1Q :
! Spanning tree :
! Bridging :
! IPMS :
! AAA :
aaa authentication console "local"
! QOS :
qos apply
! Policy manager :
! Session manager :
! SNMP :
! IP route manager :
ip router router-id 127.0.0.1
ip router primary-address 127.0.0.1
! RIP :
! OSPF :
! BGP :
! IP multicast :
! Health monitor :
! Interface :
! Link Aggregate :
! Port mirroring :
! UDP Relay :
! Server load balance :
! System service :
! VRRP :
! Web :
! AMAP :
! GMAP :
! Module :