Aurora Electronics MAGNETEK PVI-3600-OUTD-UK-F-W - Manual (Page 19)

Installation and Operator’s Manual Page 19 of 63
(PVI-3600-OUTD-UK-F-W Rev.: 1.0)
3.4 Wall Mounting
AURORA should be mounted in a vertical position as shown in figure 7.
NOTE: AURORA ratings are based on a vertical mounting position.
Although it is possible to mount AURORA in a tilted position, the
thermal performance in that case may be de-rated. In any case avoid
mounting AURORA with the front plate rotated, always make sure that
the fins of the front heat-sink are vertical.
To facilitate wall mounting a reference drawing is provided in the package (Fig.6).
Use the drawing to locate the holes on the wall. A set of standard expansion
stainless steel screws is included in the package for use in mounting the AURORA
to a masonry wall. In case of different materials make sure to select the proper
mounting hardware. Always use stainless steel mounting hardware, if the supplied
hardware is not used.
The clearance hole in the mount bracket is 8 mm.
Fig.6 Wall mounting diagram