Aurora Electronics MAGNETEK PVI-3600-OUTD-UK-F-W - Manual (Page 52)

Installation and Operator’s Manual Page 52 of 63
(PVI-3600-OUTD-UK-F-W Rev.: 1.0)
4) Confirm the choice by pressing once more the key for at least 5 seconds.
NOTE : When using RS-485 link there can be no more than 31 inverters
connected on the same link. Although you are free to choose any address
between 2 and 63 it is recommended that you use addresses between 2
and 33 for the RS-485 serial link.
NOTE : When using RS-485 link, in case one or more inverters are later
added to the system, please remember to switch back to the OFF position
the dip-switch of the former last inverter of the system.
6.6 Automatic setting
The key AUTO activates the channel to select the addresses. Only Factory
authorized personnel are able to perform this procedure.
6.7 Verifying the paralleled input configuration.
The inverter is configured at the factory for parallel inputs. The selected
configuration can be verified through the display.
1) Once defined the inverter address, per the procedure described in § 6.5 and
6.6, press the key on the right of the display for longer than 5 sec. in order to
proceed the next screen.
2
3
…
63.
AUTO
NEW ADDRESS
2