Aurora Electronics MAGNETEK PVI-3600-OUTD-UK-F-W - Manual (Page 20)

Installation and Operator’s Manual Page 20 of 63
(PVI-3600-OUTD-UK-F-W Rev.: 1.0)
Install the expansion screws in the wall so that the head of the screws is about
4mm from the wall surface. Then hang AURORA on the wall by fitting the screw
heads in the mounting slots as shown in Fig.7, and secure the screws.
Fig.7 AURORA wall mounting
It is possible to mount AURORA in a tilted position. In that case the thermal
dissipation will not be optimized and the cooling fan may start at lower ambient
temperatures than the pre-set intervention threshold.
NOTE: In case of installation of several units, MAGNETEK
recommends not to install them in parallel, superimposed, rows.
In fact the heat generated by the bottom rows will get the ambient
temperature of the upper inverters to increase. At ambient temperatures