Remove top cover, Remove front door, Installation – Outback Power Systems GS Load Center Installation Manual User Manual
Page 20
Advertising
Installation
18
Remove Top Cover
Figure 14
Removing the Top Cover from the GSLC
Remove Front Door
Figure 15
Removing the Front Door from the GSLC
To Remove the Top Cover:
1. Remove the four screws; one in each corner.
2. Lift the top off the enclosure.
Enclosure with
Top Removed
Lift up to remove.
To Remove the Front Door:
1. Open the door to about 90 degrees.
2. Lift the hinges out of the slots at the
inside edge.
Open to 90 degrees
(shown partly open)
Advertising