Outback Power Systems GS Load Center Installation Manual - Manual (Page 25)

Assembly
900-0123-01-00 Rev C 23
Installing DC Shunts
Figure 21 DC Shunts
A single 500 Adc/50 mV shunt is included
with the GSLC. Up to two more shunts
can be installed as needed. These shunts
are used in conjunction with the FLEXnet
DC battery monitor. See page 31 for
more instructions on wiring.
To mount DC Shunts:
1. Four mounting holes are located to the
lower left of the first shunt. Center each
shunt across one pair of mounting holes.
These should line up with the mounting
holes built into each shunt.
2. Using the screws included with the shunt,
attach each shunt to the GSLC enclosure.
3. Tighten the screws until secure, but do
not over-tighten.
NOTE: The GS-SBUS can be purchased
and installed to connect the
three shunts together. See
Figure 30 on page 33.
Mounting Holes for
Additional Shunts
Pre-installed Shunt
Additional Shunt Placement