Sandvik Coromant Parting and grooving - users guide - Manual (Page 14)

12
Q-Cut 151.3 – for internal machining
and small diameter face grooving
Q-Cut 151.3 is to be used for internal machining (diameters from 20–40 mm) and for face-
grooving of smaller diameters (first cut diameter from 24–40 mm).
The inserts are thinner in design in order to machine smaller diameters than the CoroCut 1-
and 2-edge inserts.
To be used together with 151.3 bars and toolholders.
Precision
grooving Face
grooving Profiling
Low feed 4G 7P
Medium feed 7G
Inserts
A programme with widths from 2–8 mm.
Q-Cut inserts for internal/facegrooving use