Sandvik Coromant Parting and grooving - users guide - Manual (Page 62)

60
Short version. Long version. Holder for small
part machining.
To minimise risk of vibration and deflection always choose:
Toolholder with smallest possible overhang. •
Toolholder with maximum shank dimension. •
Blade or holder with maximum blade width (largest possible insert seat size). •
Solid toolholders
Intended for grooving, turning and profiling applications in Coromant Capto and shank
holder versions. Available in right hand, left hand and neutral style in short and long
versions (a
r
).
This programme also includes a separate small part machining programme in smaller shank
sizes with an angled insert clamping screw for easier changing of insert. These toolholders
without offset are dedicated for sliding head machines.
Practical hints
If using screw clamped reinforced blades •
check the cutting depth limitations in separate
diagrams in Main catalogue.
Use the separate coolant adaptor for the tool
•
block in order to achieve the best coolant
supply.
Reinforced blade.
Practical hints