Sandvik Coromant Parting and grooving - users guide - Manual (Page 75)

73
Grade GC1005
A fine grained carbide substrate, PVD coated with TiAlN layer.
Most suitable for roughing of aluminium.
Grade H10
Uncoated carbide grade.
Good edge sharpness for use in aluminium alloys and Heat Resistant Super Alloys (HRSA).
Grade H13A – first choice for non-ferrous materials
Uncoated carbide grade.
Good wear resistance and toughness combined with edge sharpness.
To be used in non-ferrous and titanium materials.
Grade GC1105 – first choice for HRSA
A fine grained carbide substrate, PVD coated with TiN-TiAlN layer.
A wear resistant grade combined with sharp edges. To be used for finishing with close toler-
ances in HRSA and stainless steel.
Grade CD10 – first choice for finishing aluminium
A polycrystalline diamond (PCD) grade.
An extremely wear resistant grade giving very good surface finish. To be used only for non-
ferrous materials.
Grade CB7015 - first choice for hardened materials
High performance cubic boron nitride composite for hardened ferrous materials.
Suitable for both continious and interupted cuts.
Grade CB20
A cubic boron nitride (CBN) grade.
A wear resistant grade. To be used for machining of hardened materials, with limited feed
and depth of cut. Eliminates grinding operations.
Other grade information
Grade 1025
A fine grained substrate, PVD coated with TiAlN layer.
An excellent all round grade for all ISO-areas. The thin coating makes it suitable for sharp
edges.
Low to medium cutting speeds.