Sandvik Coromant Parting and grooving - users guide - Manual (Page 21)

19
CF
CS
CM
CR
Parting
For parting we offer dedicated geometries with the CoroCut system. These geometries are
designed to make the chip narrower than the groove and to give excellent chip control. The
geometries are designed for high feed (CR), medium feed (CM) and low feed (CF). For
extremely low feed and lowest possible cutting forces we offer the CS-geometry.
For more information, see the Main catalogue.
For more information about cutting speed, see page 74.
The CoroCut 1- and 2-edge solutions offer excellent stability and
give good results at medium cutting depth. For small cutting depths
CoroCut3 is the first choice.
For large cutting depths CoroCut 1-edge is the first choice and
Q-Cut 151.2 is second choice.
Radial feed
Insert width (Ia),
3.0 m
Feed (f
n
),
mm/r
0.05 0.1 0.2 0.3 0.4
= Recommended
starting value.
= First choice.