ADC RS-232/V24 - Manual (Page 91)

ADCP-50-304 • Issue 19 • June 1999 • Section 7: Operation
Page 7-16
© 1999, ADC Telecommunications, Inc.
Table 7-5. Change Switch Status
ACTION/DISPLAY DISPLAY DEFINITION
Enter 3. Status from the Select
Operation Menu to display:
Select Status Action
l. Display Status
2. Save Current as Configuration
Ctrl X To Exit
(1) >
To save the current configuration enter 2.
Save Current as Configuration from the
Select Status Action Menu.
This entry displays:
Select Configuration to Display or Replace
l. xxxxxxxxxxx
2. xxxxxxxxxxx
3. xxxxxxxxxxx
4. xxxxxxxxxxx
5. xxxxxxxxxxx
Ctrl X To Exit Action Menu.
(--) >
Select the configuration memory location in
which the current configuration is to be
stored. Entry of this selection shows two
status displays; the first shows the switch
configuration as currently defined, and the
second shows the switch configuration of
the selected configuration to be overwritten.
These displays are followed by:
Replace xxxxxxxxxxx with Current Status?
l. Yes
2. No
Ctrl X To Exit
(2) >
Enter l. Yes if the current configuration
is to be stored at the selected location.
Note: The previous contents of this
configuration memory will be lost after
the current configuration is stored.
l. Display Status – Redisplays the current status
followed Action Menu.
2. Save Current as Configuration – Allows storage
of the place of one of the five presently stored
configurations.
xxxxxxxxxxx – Eleven-character name of a previously
stored configuration. Up to five configurations can be
stored, each with a different eleven-character name,
Undefined configurations are initially labeled ??????
Ctrl X – Redisplays the Select Status
Allows comparison of the two configurations before
actually overwriting the stored values with the current.
l.
Yes – Allows overwriting to be performed.
2. No – Redisplays the Select Status Action Menu
for selection of a different configuration to be
overwritten.
Ctrl X – Redisplays the Select Status Action Menu.
This entry displays:
Configuration Name
Selection
Key in up to Eleven Characters
for Configuration Name
Ctrl X To Exit
(??????) >
Allows entry of a name for the new configuration to be
stored.
Enter the eleven-character name to
store the configuration. This displays:
Configuration xxxxxxxxxxx
Saved followed by the Select
Status Action Menu. xxxxxxxxxxx — Name of configuration
(up to eleven-characters).