Alliance Laundry Systems 70444901R3 - Manual (Page 12)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Control Identification
70444901 10
Operation Modes
General Modes of Operation
In each mode of operation, the user may press keypads
or communicate with the control to change the
displayed menu.
Power-up Mode
The control enters this mode at power-up. When
power is applied to the tumbler, the control becomes
active and will display its software version as “  XX”
(“XX” is the version number) for one second. If the
control was not powered down during a running cycle,
it will enter the Idle Mode. After the control completes
operation in the Power-up Mode it will enter Idle
Mode.
Idle Mode
The control is ready for operation in Idle Mode.
Control can display different menus depending on user
input (keypad press, opening or closing the loading
door, or PDA communication). If there is no user input
for 10 minutes, display will turn off.
While in Idle Mode the control will display the active
cycles. Anytime the control returns to Idle Mode after
a cycle has been run, the control will display the last
run cycle (except the first time the control is powered
up it will show the first cycle).
Press the up arrow ( ) to increment the cycle number.
Press the down arrow ( ) to decrease the cycle
number. If the Start ( ) keypad is pressed and
either the loading door or lint door is open the control
will show “  ” for five seconds or until door is
closed.
If the control is in Idle Mode, Cycle Menu is
displayed, loading and lint door closed, and the
Start ( ) keypad is pressed, control will enter Run
Mode.
Run Mode
The Control enters Run Mode during a cycle . Display
shows machine cycle time remaining, the current cycle
type, segment and temperature. Loading and lint doors
are closed during Run Mode. Press Stop ( ) keypad
to stop cycle and enter Pause Mode. Control enters
Pause Mode if loading or lint door opens. Press
Start (
) to Rapid Advance.
Rapid Advance Mode
If the Rapid Advance Option is enabled, the user can
advance a running machine cycle by pressing the
Start (
) keypad. In a Time Dry cycle, pressing the
Start ( ) keypad will decrease the remaining time
by one minute. Pressing and holding the Start ( )
keypad will decrease the remaining time by four
minutes per second until the end of the cycle.
In the Auto-Dry and Moisture Dry cycles, pressing the
Start (
) keypad will advance the cycle to the next
enabled segment. Note that Auto-Dry cycles only have
one programmable segment.
In the Cool Down segment, pressing the Start ( )
keypad will decrease the remaining time by one
minute.
When the cycle is completed, the audit counter, Total
Rapid Advance Cycles, is incremented rather than the
Total Machine Cycles audit counter. If the Rapid
Advance Option is disabled preventing a manual
Rapid Advance, the user may still execute a Rapid
Advance using the PDA or PC. Refer to PC and PDA
Application User Instructions for additional
information on using a PDA or PC to Rapid Advance a
cycle.
Pause Mode
If Stop ( ) keypad is pressed or the loading or lint
door is opened while in Run Mode, control enters
Pause Mode.
If the door was opened to enter Pause Mode, the
control will show “  ” until the door is closed or
Pause Mode is exited. If the door is closed, the control
will show “  ” for one second followed by
“  ” for one second as well as flash the
Start ( ) keypad LED one second on/one second
off.
If the Stop ( ) keypad was pressed to enter Pause
Mode and the loading door is closed, the control will
show “  ” until Pause Mode is exited.
Any time “  ” is shown on the control, the
Start ( ) keypad LED will flash one second on/one
second off to prompt the user to restart the cycle.
Error Mode
This mode will be entered to display all fatal machine
errors.