Avaya S8300 - Manual (Page 106)

Hardware installation for the G700 Media Gateway and S8300 Media Server
106 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
3. Engage both sides of the S8300 Media Server module in the interior guides and guide the
module halfway into the chassis.
Figure 10: Insert S8300
4. Align the LED module in its guides and gently push it into place, keeping the LED module
safely within its guides and maintaining an even pressure to assure that the module does
not become twisted or disengage from the guides.
Guide the longer, left side of the LED module into the chassis until the shorter, right edge of
the module can engage in its guides.
Figure 11: Align the LED module and the S8300 Media Server
5. Push steadily and firmly until the faceplates of the S8300 Media Server and the LED
module are even and then push the two units into the housing together.
6. Apply firm pressure to engage the connectors.
The connector has different length pins. The long pins will engage first to provide grounding.
Medium length and short pins will provide power and signal.