Avaya S8300 User Manual

Page 557

Advertising
background image

Configure the G700

Issue 9.1 June 2006

557

Up to four IP addresses separated by commas can be entered to form the controller list.

To set the MGP controller list

1. At the MG-???-n(configure)# prompt, type the following commands to designate the

primary, secondary, and LSP controllers for this G700:

a. clear mgc list

b. set mgc list <ip_address> [,<ip_address> [,<ip_address>

[,<ip_address>]]]

where, the first <ip_address> can be one of the following IP addresses:

For an S8700-series primary controller, the IP address of a C-LAN board that is
connected to the primary controller.

For an S8400 or S8500 primary controller, the IP address of either a C-LAN board that
is connected to the primary controller, or an Ethernet port, on the server itself, that has
been enabled for processor Ethernet connections.

For an S8300 primary controller, the IP address of the S8300.

The next three <ip_address> parameters are optional IP addresses of up to three
alternate controllers. Each of the three optional controllers can be a second C-LAN
connected to the primary controller (S8400, S8500, or S8700-series Media Servers), an
S8300 configured as an LSP, or the port enabled as the Ethernet processor port on an
S8500 configured as an LSP. The types of alternate controllers in the list depend on the
G700’s primary controller and the other controller devices it supports.

!

CAUTION:

CAUTION:

If you need to change the mgc list, you must run clear mgc list before
running set mgc list again. You can also remove a single address in the list
with the command clear mgc list <ip address>.

Table 36

describes the possible optional controllers for an S8300 and S8700/S8710 primary

controller:

Table 36: Possible optional controllers for various primary controllers

If primary
controller is

Then, controller IP addresses can be

S8300

First: IP address of the S8300 primary controller.
Next three: one, two, or three IP addresses of S8300s configured as LSPs.

S8400, S8500
or S8700,
S8710, or
S8720

First: IP address of the C-LAN for the S8400, S8500, or S8700/S8710/
S8720 primary controller or IP address of processor Ethernet-enabled port
on S8400 or S8500.
Next three: one, two, or three IP addresses of alternate C-LANs and/or
LSPs.

Advertising
This manual is related to the following products: