Avaya S8300 - Manual (Page 606)

Manual upgrade of an existing S8300A and G700 to R3.1
606 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
To disable scheduled maintenance
Scheduled daily maintenance must not interfere with the upgrade.
1. At the SAT prompt, type change system-parameters maintenance and press Enter.
2. If scheduled maintenance is in progress, set the Stop Time field to 1 minute after the
current time.
or,
If scheduled maintenance is not in progress, set the Start Time field to a time after the
upgrade will be completed.
For example, if you start the upgrade at 8:00 P.M. and the upgrade takes 90 minutes, set
the Start Time field to 21:30.
To check for translation corruption
1. At the SAT prompt, type newterm and press Enter.
2. Enter your terminal type and press Enter.
If you see the message,
Warning: Translation corruption found
follow the normal escalation procedure for translation corruption before continuing the
upgrade.
To save translations
1. At the SAT prompt, type save translation and press Enter.
2. Under Command Completion Status you should see Success.
To stop Communication Manager on an LSP
Skip this procedure if no LSPs are registered to the S8300.
For configurations with LSPs, the LSPs can run the same version or a later version of
Communication Manager than the version running on the primary controller. Normally, the
primary controller and the LSPs should run the same version of Communication Manager.
Therefore, an upgrade to an LSP is usually accompanied by an upgrade of the primary
controller.
Note:
Note:
You should upgrade the LSP before you upgrade the primary controller.