Avaya S8300 User Manual
Page 183
Administer Communication Manager
Issue 9.1 June 2006
183
2. Complete the fields as described in Administration for Network Connectivity for Avaya
Communication Manager, 555-233-504.
Note:
Note:
It is strongly recommended to use the defaults in the screen. However, for the
RTCP Enabled and RSVP Enabled fields, the entry should be n (no).
3. If the network region of the G700 (1 in this example) is different from that of the S8400,
S8500, or S8700-series CLAN board(s), you must interconnect the two regions.
Press NextPage twice to display page 3, of the Inter Network Region Connection
Management screen.
This screen shows the source region (1) and the first 15 destination network region
numbers. (Pages 4–19 show destination regions 16–250).
IP Network Region Screen, Page 3
4. Type the number for the type of codec set (1–7) that the S8400, S8500, or S8700-series
Media Server will use to interconnect the G700 and the C-LAN board(s) in the row
corresponding to the region of the C-LAN.
In this example, the C-LAN is in region 9 and codec-set type 3 is to be used for the
interconnection between region 1 and region 9. (In this example, codec type 1 is used for
communication within region 1)
The SAT command, list ip-codec-set, lists the types of codecs available on this server.
For more detail about the Inter Network Region Connection Management form, see
Administration for Network Connectivity for Avaya Communication Manager, 555-233-504.
5. Press F3 (Enter) when complete.
display ip-network-region 1
Page 3 of 19
Inter Network Region Connection Management
src dst
codec
direct
Dynamic CAC
rgn rgn
set
WAN
WAN-BW-limints
Intervening-regions
Gateway
IGAR
1
1
1
1
2
1
3
1
4
1
5
1
6
1
7
1
8
1
9
3
1
10
1
11
1
12
1
13
1
14
1
15