Avaya S8300 - Manual (Page 180)

Installing a new G700 with an S8300 using the Avaya Installation Wizard
180 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
Administering an S8400, S8500, or S8700-series primary
controller
In this case, the S8300 you have installed is configured as an LSP.
!
CAUTION:
CAUTION:
This administration applies only to the primary controller that controls the S8300
LSP that you are installing. The primary controller can be an S8400, S8500, or
S8700-series Media Server. Do not administer the S8300 LSP. Translations are
automatically copied to the LSP from the primary controller.
Skip this section and go to Administering an S8300 primary controller on page 173 if the
primary controller is an S8300.
Note:
Note:
Some of the procedures in this section may have been completed previously as
part of a normal media server installation.
This document covers only the administration of Communication Manager required for the
G700 media gateway to communicate with the primary controller over a customer’s network.
For the majority of required administration, see Administrator Guide to Avaya Communication
Manager, 03-300509, or Administration for Network Connectivity for Avaya Communication
Manager, 555-233-504.
In this section, you will use the SAT interface on the primary controller to:
● Assigning Node Names and IP Addresses for the C-LANs and LSPs
● Administering Network Regions
● Assigning LSPs to the Network Regions
● Administering IP Interfaces
● Identifying the Survivable Processor on the primary controller
Note:
Note:
For information on installing the CLAN boards on the S8400, S8500, or
S8700-series port networks and complete information on installing an S8400,
S8500, or S8700-series Media Server, see the Installation documentation on the
Documentation for Avaya Communication Manager, Media Gateways and
Servers CD, 03-300151.