Avaya S8300 - Manual (Page 184)

Installing a new G700 with an S8300 using the Avaya Installation Wizard
184 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
Assigning LSPs to the Network Regions
If the primary controller has LSPs, you can assign the LSPs to network regions. In the event of
a network failure, IP telephones assigned to a network region will register with the LSPs
assigned to that region.
This procedure assigns up to six LSPs to a network region.
To assign LSPs to a network region
1. On the IP Network Region screen, go to page 2.
IP Network Region Screen, page 2
2. Enter the names of up to six LSPs to be assigned to region 1.
The LSP names must be the same as administered on the Node Names form.
3. Submit the form.
4. Repeat for each network region to which you want to assign LSPs.
Administering IP Interfaces
To define the IP interfaces of the S8400, S8500, or S8700-series port network CLAN
boards
Note:
Note:
This should have already been established as a part of normal S8400, S8500, or
S8700-series Media Server installation.
1. Type change ip-interfaces <slot location> to open the IP Interfaces screen.
change ip-network-region 1 Page 2 of 19
IP Network Region
INTER-GATEWAY ALTERNATIVE ROUTING
Incoming LDN Extension:
Conversion To Full Public Number - Delete: Insert:
Maximum Number of Trunks to Use:
LSP NAMES IN PRIORITY ORDER SECURITY PROCEDURES
1 node-10-LSP______ 1 challenge
2 ________________ 2
3 ________________ 3
4 ________________ 4
5 ________________
6 ________________