Avaya S8300 - Manual (Page 205)

Configure an X330 Expansion Module (If Necessary)
Issue 9.1 June 2006 205
Configure an X330 Expansion Module (If Necessary)
User Guides and Quick Start Guides for the expansion modules are available on the Avaya
Support web site:
To configure an X330 Expansion Module
1. Go to the Avaya Support web site: http://avaya.com/support .
2. In the list on under Technical Database, click on LAN, Backbone, and Edge Access
Switches.
3. Under Wiring Closet & Distribution, click on P330 Stackable Switching System.
4. Click on All Documents.
5. Select the appropriate document for the expansion module you are installing.
Set rapid spanning tree on the network
Spanning Tree (STP) is a loop avoidance protocol. If you don't have loops in your network, you
don't need STP. The "safe" option is always to leave STP enabled. Failure to do so on a network
with a loop (or a network where someone inadvertently plugs the wrong cable into the wrong
ports) will lead to a complete cessation of all traffic. Rapid Spanning Tree is a fast-converging
protocol, faster than the earlier STP, that enables new ports much faster (sub-second) than the
older protocol. Rapid Spanning Tree works with all Avaya equipment, and can be
recommended.
Rapid Spanning Tree is set using the P330 Stack Processor command line interface.
To enable/disable spanning tree
1. Open a telnet session on the P330 Stack Processor, using the serial cable connected to the
Console port of the G700.
2. At the P330-x(super)# prompt, type set spantree help and press Enter to display the
set spantree commands selection.
3. To enable Spanning Tree, type set spantree enable and press Enter.
4. To set the rapid spanning tree version, type set spantree version
rapid-spanning-tree and press Enter.
The 802.1w standard defines differently the default path cost for a port compared to STP
(802.1d). In order to avoid network topology change when migrating to RSTP, the STP path
cost is preserved when changing the spanning tree version to RSTP. You can use the
default RSTP port cost by typing the CLI command set port spantree cost auto.