Avaya S8300 - Manual (Page 209)

Administer Communication Manager
Issue 9.1 June 2006 209
2. If necessary, complete the fields as described in Administration for Network Connectivity for
Avaya Communication Manager, 555-233-504.
Note:
Note:
It is strongly recommended to use the defaults in the screen. However, for the
RTCP Enabled and RSVP Enabled fields, the entry should be n (no).
3. Press F3 (Enter) to submit the screen.
Associating LSPs with Network Regions
If the primary controller has LSPs, you can associate each LSP with one or more network
regions. In the event of a network failure, IP telephones assigned to a network region will
register with an LSP associated with that region.
This procedure associates up to six LSPs with a network region.
To associate LSPs with a network region
1. On the IP Network Region screen, go to page 2.
IP Network Region Screen, page 2
2. Enter the names of up to six LSPs to be associated with region 1.
The LSP names must be the same as administered on the Node Names screen.
3. Submit the form.
4. Repeat for each network region with which you want to associate LSPs.
change ip-network-region 1 Page 2 of 19
IP NETWORK REGION
INTER-GATEWAY ALTERNATE ROUTING
Incomming LDN Extension:
Conversion to Full Public Number - Delete: Insert:
Maximum Number of Trunks to Use:
LSP NAMES IN PRIORITY ORDER SECURITY PROCEDURES
1 node-10-LSP_____ 1 challenge
2 ________________ 2
3 ________________ 3
4 ________________ 4
5 ________________ 5
6 ________________ 6