Avaya S8300 - Manual (Page 370)

Telephones and adjunct systems
370 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
● Power requirements are consistent with the 1152A1 PDU voltage and power ratings.
Refer to Appendix B in the user’s guide that comes with the unit for voltage and power
ratings.
To connect telephones and other end devices to the 1152A1 PDU
1. Connect an Ethernet cable to the telephone using an external splitter or directly (if the
device is Power over LAN Enabled).
2. Connect the opposite end of the same cable to the RJ45 wall outlet.
3. On the front panel of the 1152A1 PDU, monitor the response of the corresponding port LED.
If it lights up GREEN, the unit has identified your telephone as a Power over LAN telephone.
1151B1/C1 and 1151B2/C2 power supplies
The 1151B1/C1 and 1151B2/C2 power supplies are local power supplies. The telephones or
consoles connect directly to them through an RJ45 connector. The 1151B2/C2 has a battery
backup.
These power supplies comply with the Underwriters Laboratories Inc. (UL) Standard UL 60950
third edition.
For safety instructions, see Important safety instructions for 1151B1/C1 and 1151B2/C2 power
supplies on page 371. For installation instructions, see Connecting the 1151B1/C1 or 1151B2/
C2 power supplies on page 372.
Table 23: 1151B1/C1 and 1151B2/C2
Power Supply UL 60950 Compliance
Complies UL 60950
Certified CSA 22.2
Approved EN6950
Approved CE