Avaya S8300 - Manual (Page 460)

Manual installation of a new G700 with an S8300
460 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
Connecting directly to a target S8300
If you are at the location of the target S8300 (primary or LSP), you can connect directly to the
S8300 Services port.
To install or upgrade directly
1. Install the S8300 software by:
- Opening the Web interface and using the Avaya Installation Wizard
or,
- Opening the Web interface and using the main menu
2. Upgrade the G700 firmware by:
- Opening the Web interface and using the Avaya Installation Wizard or the Upgrade Tool
or,
- Opening a telnet session to the S8300, and then telnet to the P330 stack processor
Connecting directly to the remote primary server
(S8300, S8400, S8500, or S8700-series Media Server)
In this case, the target S8300 is an LSP. If you are at the location of the remote primary server,
you can connect directly to the remote server’s Services port.
To install or upgrade the target LSP remotely
1. Install the S8300 (LSP) software by:
- Opening the Web interface and using the Upgrade Tool
2. Upgrade the G700 firmware by:
- Opening the Web interface and using the Upgrade Tool
or,
- Opening a telnet session to the primary server and then telnet to the P330 stack
processor and perform the installation commands
Note:
Note:
For direct connections, the TFTP server must be on the Customer LAN, not on
your laptop.