Avaya S8300 - Manual (Page 468)

Manual installation of a new G700 with an S8300
468 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
Install the S8300
Inserting the S8300
To insert the S8300
!
CAUTION:
CAUTION:
Be sure to wear a properly grounded ESD wrist strap when handling the S8300
Media Server. Place all components on a grounded, static-free surface when
working on them. When picking up the hard drive, be sure to hold it only on the
edges.
1. When inserting the S8300 circuit pack, the LED module (above slot V1) must also be
removed or inserted together with the S8300.
Disengage the LED module and the S8300 circuit pack and remove them together from the
G700.
2. The LED panel (above slot V1) must be inserted together with the S8300 circuit pack.
a. Insert both the LED panel and S8300 circuit pack about 1/3 of the way into the guides
(the guides are in slot V1 for the S8300 and above slot V1 for the LED panel).
b. Push both circuit packs (together) back into the guides, gently and firmly, until the front of
each circuit pack aligns with the front of the G700.
3. Secure the S8300 faceplate with the thumb screws.
Tighten the thumb screws with a screw driver.
4. Power up the G700 by plugging in the power cord.
5. Connect the laptop to the Services port on the faceplate of the S8300.
Installing Communication Manager Software
Note:
Note:
You cannot use the SSH protocol to access the hard drive on an S8300 Media
Server that has never been installed.