Avaya S8300 - Manual (Page 469)

Install the S8300
Issue 9.1 June 2006 469
Setting telnet parameters
The Microsoft telnet application may be set to send a carriage return (CR) and line feed (LF)
each time you press Enter. The installation program interprets this as two key presses. You
need to correct this before you telnet to the server.
Note:
Note:
This procedure is done entirely on your laptop, not on the S8300.
To set telnet parameters
1. Click Start > Run to open the Run dialog box.
2. Type telnet and press Enter to open a Microsoft Telnet session.
3. Type unset crlf and press Enter.
4. Type display and press Enter to confirm that Sending only CR is set.
5. Close the window by clicking on the X in the upper-right corner.
This resets your Microsoft telnet defaults and does not need to be done each time you use
Telnet.
Remastering the hard drive and installing the software
To do before you start the upgrade
1. Verify that the S8300B is inserted in slot V1.
2. Verify good AC power connections to the G700.
3. Avaya recommends using a UPS backup for media servers.
If a UPS is present, make sure the G700 is plugged into the UPS.
4. Verify that all Ethernet connections are secure, to ensure the file transfer process is not
interrupted.
5. Insert the Unity CD in the CD-ROM drive:
- If TFTP server software is installed on your laptop, start the TFTP server program
(TFTPServer32.exe), and insert the Communication Manager unity CD in the laptop’s
CD drive.
!
CAUTION:
CAUTION:
Verify good AC power connections to the laptop. Do not attempt a remastering
using only the laptop’s battery power.
Note:
Note:
Shut down all applications on the laptop except for the TFTP server and the
telnet client. Other background applications can overly use laptop resources.