Avaya S8300 - Manual (Page 506)

Manual installation of a new G700 with an S8300
506 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
3. At the MG-001-1(configure)# prompt, type set mgp reset-times
transition-point <#_of_primary>
where <#_of_primary> is the number of primary controllers in the controller list. If the
primary controller is an S8500 or S8700/S8710/S8720, the range is from 1 to 4. If the
primary controller is an S8300, <#_of_primary> must be 1.
Configuring an X330 Expansion Module (If Necessary)
User Guides and Quick Start Guides for the expansion modules are available on the Avaya
Support web site:
To obtain the appropriate Avaya Support Web site document
1. Go to the Avaya Support web site: http://avaya.com/support .
2. In the list on under Technical Database, click on LAN, Backbone, and Edge Access
Switches.
3. Under Wiring Closet & Distribution, click on P330 Stackable Switching.
4. Click on All Documents.
5. Select the appropriate document for the expansion module you are installing.
Install New Firmware on the G700
This section describes the manual procedures to install firmware on the G700 Media Gateway
processors and media modules.
Manual upgrade procedures — G700 firmware
This section contains the following tasks:
● Verifying the Contents of the tftpboot Directory
● Determining which firmware to install on the G700
● Installing New Firmware on the P330 Stack Processor
● Installing new firmware on the G700 Media Gateway Processor
● Installing new firmware on the media modules
● Retrieving IA770 service pack files, if any